Mining Hardware Education & Facility Audits
We provide practical, hands-on masterclasses and certified on-site engineering audits tailored for Australian agricultural, commercial, and independent mining operators. Every program is delivered by experienced hardware technicians and licensed electrical professionals.
Hands-On ASIC Hardware & Diagnostics Masterclass
An intensive two-day practical workshop in our Cowwarr lab covering hashboard voltage testing, thermal paste re-application, control board firmware flashing, and component-level fault isolation.
Site Electrical & Three-Phase Load Audit
An on-site technical inspection of your shed, workshop, or commercial facility electrical infrastructure to determine safe continuous mining capacity.
Facility Airflow & Thermal Engineering Workshop
Practical training in designing positive/negative pressure ventilation, hot aisle isolation, and acoustic attenuation for high-heat environments.
Solar & Off-Grid Mining Feasibility Assessment
Custom engineering study and modeling to evaluate agricultural solar curtailment, generator integration, and diurnal mining scheduling.
Immersion & Dielectric Fluid Practical Lab
Hands-on immersion workshop covering single-phase synthetic fluids, dry cooler heat rejection, pump hydraulic curves, and gasket safety.
Selecting the Right Program for Your Setup
Not sure whether you need on-site electrical auditing, facility airflow modeling, or hands-on ASIC repair training? Review our recommendations:
- Before Purchasing Hardware: Choose our Site Electrical & Three-Phase Load Audit or Solar & Off-Grid Feasibility Assessment. Ensure your grid connection, switchboards, and solar curves can sustain continuous loads before capital is committed.
- For Machine Maintenance & Fault Repair: Enroll in our 2-Day Hands-On ASIC Hardware & Diagnostics Masterclass. Learn how to isolate failed chips, re-flow solder joints, test LDO regulators, and replace thermal paste on your own repair bench.
- For Thermal Throttling & Summer Heat: Attend our Facility Airflow & Thermal Engineering Workshop or Immersion Cooling Lab to optimize CFM intake, eliminate negative pressure vacuum, or transition to single-phase dielectric fluid cooling.